Unerklärliche Phänomene, Teil 56 1/2

A

Anonymous

Guest
Hallo zusammen!

Stoff für ein Gitarrenmysterydokuformat: Unerklärliche Pegelsprünge

Signalweg:
Tele, passive SCs -> Boss TU2 -> Fulltone OCD -> Line 6 DL4 - EH Holy Grail -> Twin

Stage 1: Alle Treter aus. Klimper klimper, alles klingt "normal"
Stage 2: Nur OCD an. Klimper klimper, alles tut wie es soll, der Pegel bleibt gleich
Stage 3: Nur Holy Grail an: Hall hall klimper, Pegel bleibt gleich.
Stage 4: Nur DL4 an an an an: Pegel bleibt gleich.
Stage 5: OCD und Holy Grail an: Schreck, massiver Pegelsprung - nach oben.
Stage 6: OCD und DL4: Der gleiche Pegelsprung.

Stage 7: Grübel. Hirnkratz. Komm nicht drauf.

Der gleiche Effekt ergibt sich, wenn man den OCD z.B. mit einem Baldringer Dual Drive ersetzt.

Ich kapier das nicht - wahrscheinlich irgendein Innenaußenimpedanzwandelwintertemperaturthema.

Weiß jemand, warum das so tut?


Gruß Jergn
 
Hey,

ich hatte das gleiche Problem: Telecaster ->OCD v4 ->MXR Carbon Copy Delay -> Hiwatt ....und es gab eine enorme Pegelanhebung. Außerdem gabs einen unangenehmen Trebleschub und die Bässe wurden wegschnitten.

Das Delay hab ich jetzt einfach vor den OCD gehängt (obwohl das ja sonst nicht klingt) und es funktioniert bestens, ohne Pegelanhebung und Basscut.

Folgendes habe ich in einem amerikanischen Forum gefunden:

"The output of the OCD is an unbuffered volume pot... 100k or 500k depending on which version that you have. The pedal following the OCD will put a load on the volume pot and reduce the overall signal volume, significantly or not depending on the input impedance of the second pedal. A buffered input pedal will not put much load on it and the signal will come through stronger than if the pedal has a lower input Z. The volume drop/boost will be more noticeable with the 500k version than the 100k. This same problem applies to any other pedal with a volume pot on the output. The Fuzzface should produce a similar response..."

"If there's a pedal following your OCD that has true bypass, then the capacitance of the cable between it and the amp will cause noticeable treble rolloff when that pedal is bypassed, but it might not do this when that pedal is engaged. In this situation, it depends upon the output impedance of that pedal's circuit. If it has a low output impedance, then it's a similar situation when that pedal is engaged as when you have a buffered bypass pedal following the OCD."

http://www.seymourduncan.com/forum/show ... p?t=187202

Grüße
David
 

Beliebte Themen

Zurück
Oben Unten